Download Circuit Simulation with Inductors and Transformers Based on the Jiles-Atherton Model of Magnetization
The sound of a vacuum tube guitar amplifier may be significantly influenced by the non-linear behavior of its output transformer, which therefore should also be considered in digital simulations. In this work, we develop a model for inductors and transformers with the magnetization following the model of Jiles and Atherton. For this purpose, the original magnetization model is rewritten to a differential equation with respect to time which can then easily be integrated into a previously developed circuit simulation framework. The model thus derived is then exercised in the simulation of three simple circuits where it shows the expected behavior.
Download Digitizing the Schumann PLL Analog Harmonizer
The Schumann Electronics PLL is a guitar effect that uses hardwarebased processing of one-bit digital signals, with op-amp saturation and CMOS control systems used to generate multiple square waves derived from the frequency of the input signal. The effect may be simulated in the digital domain by cascading stages of statespace virtual analog modeling and algorithmic approximations of CMOS integrated circuits. Phase-locked loops, decade counters, and Schmitt trigger inverters are modeled using logic algorithms, allowing for the comparable digital implementation of the Schumann PLL. Simulation results are presented.
Download Simulating guitar distortion circuits using wave digital and nonlinear state-space formulations
This work extends previous research on numerical solution of nonlinear systems in musical acoustics to the realm of nonlinear musical circuits. Wave digital principles and nonlinear state-space simulators provide two alternative approaches explored in this work. These methods are used to simulate voltage amplification stages typically used in guitar distortion or amplifier circuits. Block level analysis of the entire circuit suggests a strategy based upon the nonlinear filter composition technique for connecting amplifier stages while accounting for the way these stages interact. Formulations are given for the bright switch, the diode clipper, a transistor amplifier, and a triode amplifier.
Download Extended Source-Filter Model for Harmonic Instruments for Expressive Control of Sound Synthesis and Transformation
In this paper we present a revised and improved version of a recently proposed extended source-filter model for sound synthesis, transformation and hybridization of harmonic instruments. This extension focuses mainly on the application for impulsively excited instruments like piano or guitar, but also improves synthesis results for continuously driven instruments including their hybrids. This technique comprises an extensive analysis of an instruments sound database, followed by the estimation of a generalized instrument model reflecting timbre variations according to selected control parameters. Such an instrument model allows for natural sounding transformations and expressive control of instrument sounds regarding its control parameters.
Download Musikverb: A Harmonically Adaptive Audio Reverberation
We present MusikVerb, a novel digital reverberation capable of adapting its output to the harmonic context of a live music performance. The proposed reverberation is aware of the harmonic content of an audio input signal and ‘tunes’ the reverberation output to its harmonic content using a spectral filtering technique. The dynamic behavior of MusikVerb avoids the sonic clutter of traditional reverberation, and most importantly, fosters creative endeavor by providing new expressive and musically-aware uses of reverberation. Despite its applicability to any input audio signal, the proposed effect has been designed primarily as a guitar pedal effect and a standalone software application.
Download Taming the Red Llama—Modeling a CMOS-Based Overdrive Circuit
The Red Llama guitar overdrive effect pedal differs from most other overdrive effects because it utilizes CMOS inverters, formed by two metal-oxide-semiconductor field-effect transistors (MOSFETs), instead of a combination of operational amplifiers and diodes to obtain nonlinear distortion. This makes it an interesting subject for virtual analog modeling, obviously requiring a suitable model for the CMOS inverters. Therefore, in this paper, we extend a well-known model for MOSFETs by a straight-forward heuristic approach to achieve a good match between the model and measurement data obtained for the individual MOSFETs. This allows a faithful digital simulation of the Red Llama.
Download Coefficient-modulated first-order allpass filter as distortion effect
A novel approach to implement the distortion effect is introduced. The proposed approach is based on time-varying phase distortion of the input signal, and it is implemented using a coefficient modulated first-order allpass filter. This new technique provides control over the distorted band with a proper choice of the modulating signal. By choosing a modulating signal that applies the phase distortion only for low frequencies, the aliasing often generated by conventional distortion effects, which modify the signal amplitude, can be greatly reduced. Modulation signals that produce distortion effects applicable for electric guitar playing are also discussed. Sound examples on the use of the filter can be found at http://www.acoustics.hut.fi/~jpekonen/ Papers/dafx08/.
Download The Fender Bassman 5F6-A Family of Preamplifier Circuits—A Wave Digital Filter Case Study
The Fender Bassman model 5F6-A was released in 1958 and has become one of the most revered guitar amplifiers of all time. It is the progenitor of a long line of related Fender designs in addition to inspiring Marshall’s first amplifier design. This paper presents a Wave Digital Filter study of the preamplifier circuit of 5F6-Abased amplifiers, utilizing recent theoretical advances to enable the simultaneous simulation of its four nonlinear vacuum tube triodes. The Dempwolf triode model is applied along with an iterative Newton solver to calculate the scattering at the 25 port R-type adapter at the root of the WDF tree. Simulation results are compared to “ground truth” SPICE data showing excellent agreement.
Download Parametric Audio Coding of Bass Guitar Recordings Using a Tuned Physical Modeling Algorithm
In this paper, we propose a parametric audio coding framework that combines the analysis and re-synthesis of electric bass guitar recordings. In particular, an existing synthesis algorithm that incorporates 11 playing techniques is extended by two calibration algorithms. Both the temporal and spectral decay parameters as well as the inharmonicity coefficient are set according to the fretboard position on the instrument. Listening tests show that there is still a gap in perceptual quality between real-world instrument recordings and the re-synthesized versions. Due to this gap, the perceived improvement due to the model calibration is only small. Second, the listening tests reveal that the plucking styles are more important towards realistic synthesis results than expression styles.
Download Simulation of the Diode Limiter in Guitar Distortion Circuits by Numerical Solution of Ordinary Differential Equations
The diode clipper circuit with an embedded low-pass filter lies at the heart of both diode clipping “Distortion” and “Overdrive” or “Tube Screamer” effects pedals. An accurate simulation of this circuit requires the solution of a nonlinear ordinary differential equation (ODE). Numerical methods with stiff stability – Backward Euler, Trapezoidal Rule, and second-order Backward Difference Formula – allow the use of relatively low sampling rates at the cost of accuracy and aliasing. However, these methods require iteration at each time step to solve a nonlinear equation, and the tradeoff for this complexity must be evaluated against simple explicit methods such as Forward Euler and fourth order Runge-Kutta, which require very high sampling rates for stability. This paper surveys and compares the basic ODE solvers as they apply to simulating circuits for audio processing. These methods are compared to a static nonlinearity with a pre-filter. It is found that implicit or semiimplicit solvers are preferred and that the filter/static nonlinearity approximation is often perceptually adequate.