Download Low-order allpass Interpolated Delay Loops
This paper presents empirical and theoretical results for a delay line cascaded with a second-order allpass filter in a feedback loop. Though such a structure has been used for years to model stiff vibrating strings, the complete range of behavior of such a structure has not been fully described and analyzed. As shown in this paper, in addition to the desired behavior of providing a frequencydependent delay line length, other phenomena may occur, such as “beating” or “mode splitting.” Associated analysis simulation results are presented.
Download Handling Inharmonic Series with Median-Adjustive Trajectories
A new method for the analysis of inharmonic instrumental tones is presented. The method exploits an equation derived from the well-know inharmonic series equation, where the inharmonicity coefficient is balanced with the frequencies and numbers of any two partials extracted from a pseudo-harmonic series. A serial search for increasingly deviating spectral peaks is aided with the integrated refinement of increasingly reliable inharmonicity coefficient and fundamental frequency estimates. This firsthand approach to the problem of evaluating inharmonic spectra brings about an unprecedented level of simplicity, efficiency and accuracy.
Download Sound synthesis using an allpass filter chain with audio‐rate coefficient modulation
This paper describes a sound synthesis technique that modulates the coefficients of allpass filter chains using audio-rate frequencies. It was found that modulating a single allpass filter section produces a feedback AM–like spectrum, and that its bandwidth is extended and further processed by non-sinusoidal FM when the sections are cascaded. The cascade length parameter provides dynamic bandwidth control to prevent upper range aliasing artifacts, and the amount of spectral content within that band can be controlled using a modulation index parameter. The technique is capable of synthesizing rich and evolving timbres, including those resembling classic virtual analog waveforms. It can also be used as an audio effect with pitch-tracked input sources. Software and sound examples are available at http://www.acoustics.hut.fi/publications/papers/dafx09-cm/
Download Physical Modeling for Spatial Sound Synthesis
This contribution combines techniques for sound synthesis and spatial reproduction for a joint synthesis of the sound production and sound propagation properties of virtual string instruments. The generated sound field is reproduced on a massive multichannel loudspeaker system using wave field synthesis techniques. From physical descriptions of string vibrations and sound waves by partial differential equations follows an algorithmic procedure for synthesis-driven wave field reproduction. Its processing steps are derived by mathematical analysis and signal processing principles. Three different building blocks are addressed: The simulation of string vibrations, a model for the radiation pattern of the generated acoustical waves, and the determination of the driving signals for the multichannel loudspeaker array. The proposed method allows the spatial reproduction of synthetic spatial sound without the need for pre-recorded or pre-synthesized source tracks.
Download Spring Reverberation: A Physical Perspective
Spring-based artificial reverberation was one of the earliest attempts at compact replication of room-like reverberation for studio use. The popularity and unique sound of this effect have given it a status and desirability apart from its original use. Standard methods for modeling analog audio effects are not well suited to modeling spring reverberation, due to the complex and dispersive nature of its mechanical vibration. Therefore, new methods must be examined. A typical impulse responses of a spring used for reverberation is examined, and important perceptual parameters identified. Mathematical models of spring vibration are considered, with the purpose of drawing conclusions relevant to their application in an audio environment. These models are used to produce new results relevant to the design of digital systems for the emulation of spring reverberation units. The numerical solution of these models via the finite difference method is considered. A set of measurements of two typical spring reverberation units are presented.
Download Automated Equalization for Room Resonance Suppression
Estimating room resonances in locations of big events and looking for counter-measures are normally done by sound engineers, mainly before the beginning of the event. In this paper an automation to enhance the audio quality in event rooms by suppressing the room resonances with a parametric equalizer of several high-Q peak filters is proposed. The room characteristics can be identified with few measurements in the listening area during the event, without applying an additional measuring signal (using its original sound signal). Based on this room characteristics the equalization filters are automatically designed. The results of several rooms tested with the automated equalization for room resonance suppression are presented as well as a discussion on the covered topics.
Download Automatic Noise Gate Settings for Multitrack Drum Recordings
A method has been developed for automating the settings of a noise gate. The method has been applied to a kick drum track containing bleed from secondary drum sources and white noise. The optimal settings are found by maximising the signal to distortion ratio (SDR). The SDR has contributions from the distortion caused to the kick drum signal, and the residual bleed and noise. These two components are weighted, enabling the gate to be controlled by a single parameter. It is shown that the improvement in the SDR can be obtained when the two components of the SDR are approximated, enabling the optimal settings to be calculated from the noisy signal and a single kick drum hit. It is found that the optimal threshold is slightly above the peak level of the noise component of the signal.
Download Real-Time Beat-Synchronous Analysis of Musical Audio
In this paper we present a model for beat-synchronous analysis of musical audio signals. Introducing a real-time beat tracking model with performance comparable to offline techniques, we discuss its application to the analysis of musical performances segmented by beat. We discuss the various design choices for beat-synchronous analysis and their implications for real-time implementations before presenting some beat-synchronous harmonic analysis examples. We make available our beat tracker and beatsynchronous analysis techniques as externals for Max/MSP.
Download A Frequency Domain Adaptive Algorithm for Wave Separation
We propose a frequency domain adaptive algorithm for wave separation in wind instruments. Forward and backward travelling waves are obtained from the signals acquired by two microphones placed along the tube, while the separation filter is adapted from the information given by a third microphone. Working in the frequency domain has a series of advantages, among which are the ease of design of the propagation filter and its differentiation with respect to its parameters. Although the adaptive algorithm was developed as a first step for the estimation of playing parameters in wind instruments it can also be used, without any modifications, for other applications such as in-air direction of arrival (DOA) estimation. Preliminary results on these applications will also be presented.
Download Source-Filter based Clustering for Monaural Blind Source Separation
In monaural blind audio source separation scenarios, a signal mixture is usually separated into more signals than active sources. Therefore it is necessary to group the separated signals to the final source estimations. Traditionally grouping methods are supervised and thus need a learning step on appropriate training data. In contrast, we discuss unsupervised clustering of the separated channels by Mel frequency cepstrum coefficients (MFCC). We show that replacing the decorrelation step of the MFCC by the non-negative matrix factorization improves the separation quality significantly. The algorithms have been evaluated on a large test set consisting of melodies played with different instruments, vocals, speech, and noise.