Download Monophonic Pitch Detection by Evaluation of Individually Parameterized Phase Locked Loops This paper describes a new efficient and sample based monophonic pitch tracking approach using multiple phase locked loops (PLLs). Hereby, distinct subband signals traverse pairs of individually parameterized PLLs. Based on the relation of the instantaneous pitch sample of respective PLLs to one another, relevant features per pitch candidate are derived. These features are combined into pitch candidate scores. Pitch candidates which exhibit the maximum score per sampling instance and exceed a voicing threshold, contribute to the overall pitch track. Evaluations with up to date datasets show that the tracking performance, compared to implementations which use only one PLL has significantly improved and nearly approaches the scores of a state of the art monophonic pitch tracker.
Download Time-Domain Chroma Extraction In this paper, a novel chroma extraction technique called TimeDomain Chroma Extraction (TDCE) is introduced. In comparison to many other known schemes, the calculation of a time-frequency representation is unnecessary since the TDCE is a pure sample-bysample technique. It mainly consists of a pitch tracking module that is implemented with a phase-locked loop (PLL). A set of 24 bandpass filters over two octaves is designed with the F 0 output of the pitch tracker to estimate a chroma vector. To verify the performance of the TDCE, a simple chord recognition algorithm is applied to the chroma output. The experimental results show that this novel time-domain chroma extraction technique yields good results while requiring only minor complexity and thus, enables the extraction of musical features in real-time on low-cost DSP platforms.
Download Modulation And Delay Line Based Digital Audio Effects In the field of musicians and recording engineers audio effects are mainly described and indicated by their acoustical effect. Audio effects can also be categorized from a technical point of view. The main criterion is found to be the type of modulation technique used to achieve the effect. After a short introduction to the different modulation types, three more sophisticated audio effect applications are presented, namely single sideband domain vibrato (mechanical vibrato bar simulation), a rotary speaker simulation, and an enhanced pitch transposing scheme.
Download Automatic Decomposition of Non-linear Equation Systems in Audio Effect Circuit Simulation In the digital simulation of non-linear audio effect circuits, the arising non-linear equation system generally poses the main challenge for a computationally cheap implementation. As the computational complexity grows super-linearly with the number of equations, it is beneficial to decompose the equation system into several smaller systems, if possible. In this paper we therefore develop an approach to determine such a decomposition automatically. We limit ourselves to cases where an exact decomposition is possible, however, and do not consider approximate decompositions.
Download Efficient linear prediction for digital audio effects In many audio applications an appropriate spectral estimation from a signal sequence is required. A common approach for this task is the linear prediction [1] where the signal spectrum is modelled by an all-pole (purely recursive) IIR (infinite impulse response) filter. Linear prediction is commonly used for coding of audio signals leading to linear predictive coding (LPC). But also some audio effects can be created using the spectral estimation of LPC. In this paper we consider the use of LPC in a real-time system. We investigate several methods of calculating the prediction coefficients to have an almost fixed workload each sample. We present modifications of the autocorrelation method and of the Burg algorithm for a sample-based calculation of the filter coefficients as alternative for the gradient adaptive lattice (GAL) method. We discuss the obtained prediction gain when using these methods regarding the required complexity each sample. The desired constant workload leads to a fast update of the spectral model which is of great benefit for both coding and audio effects.
Download Low-delay vector-quantized subband ADPCM coding Several modern applications require audio encoders featuring low data rate and lowest delays. In terms of delay, Adaptive Differential Pulse Code Modulation (ADPCM) encoders are advantageous compared to block-based codecs due to their instantaneous output and therefore preferred in time-critical applications. If the the audio signal transport is done block-wise anyways, as in Audio over IP (AoIP) scenarios, additional advantages can be expected from block-wise coding. In this study, a generalized subband ADPCM concept using vector quantization with multiple realizations and configurations is shown. Additionally, a way of optimizing the codec parameters is derived. The results show that for the cost of small algorithmic delays the data rate of ADPCM can be significantly reduced while obtaining a similar or slightly increased perceptual quality. The largest algorithmic delay of about 1 ms at 44.1 kHz is still smaller than the ones of well-known low-delay codecs.
Download Improved PVSOLA Time Stretching and Pitch Shifting for Polyphonic Audio An advanced phase vocoder technique for high quality audio pitch shifting and time stretching is described. Its main concept is based on the PVSOLA time stretching algorithm which is already known to give good results on monophonic speech. Some enhancements are proposed to add the ability to process polyphonic material at equal quality by distinguishing between sinusoidal and noisy frequency components. Furthermore, the latency is reduced to get closer to a real time implementation. The new algorithm is embedded into a flexible pitch shifting and time stretching framework by adding transient detection and resampling. A subjective listening test is used to evaluate the new algorithm and to verify the improvements.
Download A Measurement Technique for Highly Nonlinear Transfer Functions This paper presents a new method to estimate nonlinear transfer functions of tube amplifiers or distortion effect stages. A special test signal and a sorting algorithm allow the calculation of the nonlinear transfer functions. PSPICE simulations of a tube amplifier as well as real-time measurements of a tube amplifier with a high quality 24bit/96kHz sound card will be presented.
Download Downmix compatible conversion from mono to stereo in time- and frequency-domain Even in a time of surround and 3D sound, many tracks and recordings are still only available in mono or it is not feasible to record a source with multiple microphones for several reasons. In these cases, a pseudo stereo conversion of mono signals can be a useful preprocessing step and/or an enhancing audio effect. The conversion proposed in this paper is designed to deliver a neutral sounding stereo image by avoiding timbral coloration or reverberation. Additionally, the resulting stereo signal is downmix-compatible and allows to revert to the original mono signal by a simple summation of the left and right channels. Several configuration parameters are shown to control the stereo panorama. The algorithm can be implemented in time-domain or also in the frequency-domain with additional features, like center focusing.
Download Signal-Matched Power-Complementary Cross-Fading and Dry-Wet Mixing The blending of audio signals, called cross-fading, is a very common task in audio signal processing. Therefore, digital audio workstations offer several fading curves to select from. The choice of the fading curve typically depends on the signal characteristics and is supposed to result in a mixed signal featuring power and loudness close to the input signals. This work derives a correlationbased design of the fading curves to achieve exact power consistency to avoid audible fluctuations of the signal’s loudness. This principle is extended to the problem of mixing original signals with effect-processed signals using the dry-wet balance. Weighting coefficients for dry and wet signals are derived which realize the desired dry-wet balance but maintain the signal power.